I’ve made numerous mentions in recent posts to “the list”. It’s the checklist that lives on my Palm Centro,. It was compiled as we headed toward the Chesapeake, and it drove the activities surrounding our maintenance haulout and stopover for the 40 days we were in maintenance mode. That the list comprises nearly the same number of entries as days spent in maintenance mode is pure coincidence. My father lives on with his lists, although his were always on paper in a spiral notebook! I thought it might be interesting or amusing to post the list. It’s in a sort of order, the objective was to have an asterisk at each entry, signifying completion! We’re back in cruising mode now, and a new list takes root- it’s just not quite as extensive!
*Maint May ’10
*Pressure wash decks
*Clean hull w/ On & Off
*Polish & Wax bow & to lower rubrail
*Thruster seals?
*Clean cooler
*Sand & Paint Bottom
*Clean & Prop speed prop/thruster
*Torque prop nuts
*Thruster zincs
*Thruster seal stbd
*Change Cooler/Hull zincs
*Repl cotter key stbd swimdeck hinge
*LAUNCH
*Replace shackle on Rocna, reverse chain
*Re-mark anchor chain
*Paint winch frames
*Repl winch-boom clamp hdwe
*Repair fwd scupper FG
*Gelcoat PH roof @ pad eyes
*Polish out rubrail at Port scupper
*Polish & Wax hull
*Varnish cap rails
*Refinish P/H door windows
*Varnish saloon door threshold
*Repair trim at port PH door upper fwd
*Repl bilge buster module
*Trim for base of saloon door- 25×1-1/2
*Close outboard cockpit scuppers
*R&R / clean dryer vent
*Trim saloon door striker/gelcoat
*Install gasket on Laz. hatch
*Re-cement stickers- dink
*Install add’l cockpit courtesy light
*Repl main engine temp sender
*F/B monitor -Argonaut G212P
*Video camera install aft
*Video card for computer
*Replace fastener hardware on FB windscreen
*Replace holding tank filter
*R&R Tundra/Vitrifrigo fridge
*Repl. main eng. thermostat
*New toolbox & fab roller ass’y
Lisa on 21 Jun 2010 at 3:31 PM #
You are your fathers Son